Call For Order 01843-526720
odel | ATO-DVP-ES2 | ||||||
Builit-in I/O | 16 / 20 / 24 / 32 / 40 / 60 I/O points | ||||||
Power Supply | 100 ~ 240V AC (-15% ~ +10%), 50/60Hz ±5% | ||||||
Connector | European standard removable terminal block (Pin pitch: 5mm) | ||||||
Operation | ATO-DVP-ES2 PLC starts to run when the power rises to 95~100V AC and stops when the power drops to 70V AC. If the power is suddenly cut off, the PLC will continue running for 10ms. | ||||||
Power Supply Fuse | 2A / 250V AC | ||||||
Power Consumption | 30VA | ||||||
DC 24V Current Output *1 | 500mA | ||||||
Power Supply Protection | DC 24V output short circuit protection | ||||||
Voltage Withstand | 1500VAC (Primary-secondary), 1500VAC (Primary-PE), 500VAC (Secondary-PE) | ||||||
Insulation Resistance | >5MΩ at 500VDC (between all I/O points and ground) | ||||||
Noise Immunity | ESD (IEC 61131-2, IEC 61000-4-2): 8kV Air Discharge EFT (IEC 61131-2, IEC 61000-4-4): Power Line: 2kV, Digital I/O: 1kV, Analog & Communication I/O: 1kV RS (IEC 61131-2, IEC 61000-4-3): 26MHz ~ 1GHz, 10V/m | ||||||
Grounding | The diameter of grounding wire shall not be less than that of L, N terminal of the power supply. (When many PLCs are in use at the same time, please make sure every PLC is properly grounded.) | ||||||
Environment | Operation: 0°C~55°C (temperature), 5~95% (humidity), pollution degree 2 Storage: -25°C~70°C (temperature), 5~95% (humidity) | ||||||
Approvals | UL508, European community EMC Directive 89/336/EEC and Low Voltage Directive 73/23/EEC | ||||||
Vibration/Shock Immunity | International standards: IEC61131-2, IEC 68-2-6 (TEST Fc)/ IEC61131-2 & IEC 68-2-27 (TEST Ea) | ||||||
Weight | See below “Selection Table” | ||||||
Note: *1. It is suggested that the power output should not be supplied to HMIs. |